开云体育

Ross: If that didn't help I think we have to look at what else can cause it. Can you send me your Mach2Mill.xml file and the G-Code file so I can run a few tests... Thanks, Art www.artofcnc.ca

Interesting... i've not used a lot the 4 th axis until yet so i don't have continous 4th axis moves experience yet. I just made indexed parts. I will check when i'll use it. Olivier.

Hi all. Verify position don't work if we have center axis ref switches and we are on the switch off side of the ramp. You will need to manually move the machine to the other side before the verify

I tried this, No difference either way. I see a Blend Factor on the Corrections page, but it is read only. How do I change it? It reads 180.00 now. In the manual it says the blend factor should be

wrote: Olivier I did the Sub for the Y axis and it worked GREAT!!! I also can tell you that the other axis (ABC) do NOT go throught the Accel that is set in the table. I tried to run the mill with the

Ross: Try both. Just check plasma to see if it helps, and then uncheck Angualr disable and set the angle to 91 degrees in the box labeld Blend Factor on the corrections page. Then uncheck Plasma and

<digitalaudiopro@w...> wrote: friction remain. If I don't think that is the problem as I have no center set up and I don't have a part in the chuck... I have about 25 Deg/sec^2 accel and 25 Vel for

The manual said something about a blending factor. Where do I set that up? Or do I just enable plasma mode and disable the Angular Discriminator? Thanks...Ross

Ross: On the logic tab there is a Plamsa Checkbox on the logic config, there is also a checkbox for disabling the angular descriminator... Art www.artofcnc.ca

Brian, i had this kind of problem with my A axis and was simply a friction problem when i was using an opposite center. Try to connect it to another linear output to see if the problem remain. If yes

there to Art.... I installed Version 4 but I still don't see anything regarding Plasma CV Mode in any of the config screens. Can you point me in the right direction? Thanks...Ross

Peter: No, that should work fine. As long as one slot is large enough in comparison to the others it should work. Check the "#Slots" DRO, if it is correct and stable, then all is well, if it is 0,

Biran: Could be, but one of the reasons I need to get rid of 2.0 and move to 4.0 is the vast number of fixes and repairs in version 4.0. Version 2.0 is a very stable program, but it does have some

Hi : Yup , try "None" or "Mach1Pass" (Note the caps...) Thanks, Art www.artofcnc.ca

Art, On my CNC lathe I have a 16 slot index disc. The 16 slots are cut into the disk from the perimeter. The ratio of the width of each slot is 50%. That is the waveform of the signal coming from the

Hi Derek, It sounds like the servo is overshooting position and then creeping back. Try tightening your quill lock just a little at a time and see if that helps. The quill has very little mechanical

That was it!!! Thanks a bunch. Chris Seeley wrote: settings. I it. I to

following 100, A I am Home, but I will test it first thing when I get into the shop. There may be some thing with the feed??? brian

Try "None" Best, Ed Gilbert Gilbert Engineered Systems 632 Warrenton-Embro Road Macon, NC 27551 252-257-0539

wrote: Yes I am. Derek