Art,
On my CNC lathe I have a 16 slot index disc. The 16 slots are cut into the
disk from the perimeter.
The ratio of the width of each slot is 50%. That is the waveform of the
signal coming from the opto interrupter is a square wave with a 50% duty
cycle.
From the software's point of view, will it be a problem if I enlarge one of
the slots by 50% to give that slot a duty cycle of 75%
Thanks,
Peter Homann
mailto:Peter.Homann@...
Adacel Technologies Limited,
250 Bay St, BRIGHTON, 3186, AUSTRALIA
<>
Telephone +61 (3) 8530 7777, Facsimile +61 (3) 9596 2960
Mobile 0421-601 665
