Ross:
Try both. Just check plasma to see if it helps, and then uncheck Angualr
disable and set the angle to 91 degrees in the box labeld Blend Factor on
the corrections page.
Then uncheck Plasma and run with just angualr descriminator. All three
are valid modes to try.
Good luck,
Art
www.artofcnc.ca
toggle quoted message
Show quoted text
----- Original Message -----
From: "rrc62_03782" <rrc62@...>
To: <mach1mach2cnc@...>
Sent: Tuesday, February 24, 2004 10:33 AM
Subject: [mach1mach2cnc] Re: Radius Error...Update
--- In mach1mach2cnc@..., Art <fenerty@a...> wrote:
Ross:
On the logic tab there is a Plamsa Checkbox on the logic config, there
is
also a checkbox for disabling the angular descriminator...
The manual said something about a blending factor. Where do I set that
up? Or do I
just enable plasma mode and disable the Angular Discriminator?
Thanks...Ross
Yahoo! Groups Links
