WOW! Seems like a lot of hoops to jump through to use the Saver software
when measuring impedance. The "VNA View" software does it slick as can
be. So, I suppose that the thought is to use the "VNA View" software when
measuring impedances or just the stand alone unit ... at least until they
get that functionality working properly in Saver.
*Ralph*
*WA2PUX*
*YouTube Channel:*
Electronics for the Inquisitive Experimenter
On Wed, May 11, 2022 at 3:28 PM Rich NE1EE <TheDustyKey@...>
wrote:
On 2022-05-11 15:46:+0000, you wrote:
However, the Saver software ...
<Snip>Open calibration and enter 500 ps as an offset delay
<snip>The phase does not move ==> the Offset Delay does nothing.
What am I doing wrong?
Maybe nothing :-) There are some things in Saver that don't work well.
I havna tried this approach, but have applied e-delay on my -H4, and it
works as expected.
I take two approaches to using remote software.
1. Cal the device, including e-delays, and tell the software to use that
cal data, even if I use multiple sweeps.
2. Reset the device, so that there is no cal, then do the cal in software.
It might be that this is the only way the Offset Delay can be applied.
Please try that...and let us know. I assume from the lack of responses that
no one reading so far, I included, know the answer, and I am not set up to
run a test.
~R~
