On 2022-05-11 15:46:+0000, you wrote:
However, the Saver software ...
<Snip>Open calibration and enter 500 ps as an offset delay
<snip>The phase does not move ==> the Offset Delay does nothing.
What am I doing wrong?
Maybe nothing :-) There are some things in Saver that don't work well.
I havna tried this approach, but have applied e-delay on my -H4, and it works as expected.
I take two approaches to using remote software.
1. Cal the device, including e-delays, and tell the software to use that cal data, even if I use multiple sweeps.
2. Reset the device, so that there is no cal, then do the cal in software. It might be that this is the only way the Offset Delay can be applied. Please try that...and let us know. I assume from the lack of responses that no one reading so far, I included, know the answer, and I am not set up to run a test.
~R~
Rich NE1EE