开云体育

Richard, I am glad you are enjoying using your MallinCams with your ServoCAT driven UC18. For many years, I used my 17.5” TeleKit with ServoCAT and MallinCams to observe things not visible from my

Filippo, Hello sir! Contact me direct - lets figure out what is going on. I can tell you there is no reason why the control system, or at least the ServoCAT, would cause a move after 20 minutes...

Wow Richard you really got it made! Jim

Thank you Richard, very nice image. I tried to image a big object (M101 as shown). After 20 minutes the field shifts to a direction so I have to adjust it otherwise this big object goes away from the

Filippo, My video camera software takes care of this for me. I use Mallincam video products that can de-rotate, and correct most tracking errors. I use the DS287C camera that give me a very small

Hi Richard, Hi all, thank you for your message. I am still trying to solve a specific problem in imaging DSO with my dobson but apparently there was no way to manage it. My system is SC with Nexus

After my 2 star alignment last night I set the Argo Navis to 'From Planetaruim" and retired to my recliner. My UC18 dob "system" then sat out on my deck in range of my wifi and performed flawlessly.

There is a happy ending to this story.? Several people suggested to me that I try the Argo Navis instead of the Nexus DSC and I did. That solved my problem.? I am now able to connect my scope to

Mike, with the changes in place I do see that you are now properly working. Good to know. Have fun! Gary Myers StellarCAT

the cable, in the form of 2 wraps (3 turns) by design will "screw" itself along the surface as you go up and then the opposite direction when you go down. The dams at the end of the flat surface are

no picture - please email me direct techsupport @ sevocat .com g.

Gary, I attached a picture after making the adjustments. ?To shift the mirror box i adjusted both the teflon pads on the lateral surface of rocker arms and the pads on the inside of the rocker box

The drive cable is wound the wrong way! The end going up should be closest to the mirror box. Must be a real pain trying to 'thread' that up in there as is. Also - indeed the drive roller is over

Gary, Thanks for the quick response. ?I attached two pictures. ?The cable stop hardware has minimized the problem but not stopped it. ?The one question i have is the spool is not located directly

Mike, The cable stop - has it eliminated the issue? If not please send a picture of the cable wrapped around the drive roller when disengaged and a 2nd picture when engaged. Also a picture of the

Occasionally the declination cable comes loose and unwinds from the spool drive. ?I have installed the cable stop made by Markless Astronomics and piece a piece of Gorilla tape that has minimized the

WOW! I don't think I remember ever having had someone break a UC AZ motor shaft! It is pretty hearty material - stainless steel shaft material. So you'll need to contact me direct,

I have a 18 in UC, it has a broken drive shaft on AZ servo. Anyone know where I can find a replacement shaft? ?I work on RC helicopters servos and looks like I could install a new one made to specs.

There is a delay on power up - whichever 'unit', the ServoCAT or the Argo Navis, comes up last, from that point it takes about 12 seconds before you'd hear the beep. More than likely you heard,

Looking for a troubleshooting procedure for the following: 15" classic Obsession with Argo-Navis & Gen 2 ServoCat and powered ground board. When I used it last month everything worked fine but I did