¿ªÔÆÌåÓýHi, Phil, ? I did exactly what you wrote below and it worked fine. I stored it to an empty memory location and the offset direction and frequency were both as specified. I used the frequency you did just in case there was something special about that and it behaved no differently from the ones I already have stored. I didn't have to SAVE twice, though. ? I get tangled up sometimes if I forget where I am in the sequence of keystrokes. I think MENU > number > MENU > change > MENU > confirm > EXIT and I get along ok most of the time. I tend to forget the third MENU entry and that eliminates the change I am trying make. ? 73, ? Maynard W6PAP ? ? ? ? On Thursday, December 01, 2022 08:42:19 PM Phil, WF3W wrote:
> Gday Maynard, Thanks for your reply! Forgiver me but, I remember something > about saving twice but it isnt working, although the rig says receiving or > transmitting freq after each save. Here's what Im doing: Enter the receive > freq, in VFO mode, in top register - 224.580 Go to MENU item 27 and DELETE > any channels to which I will assign, new, info Go to MENU item 25, SFT-D, > enter DOWN Go to MENU item 26, OFFSET, enter 1.600 Goto MENU item 27, > MEM-CH, enter a deleted channel number and SAVE item 27, MEM-CH, > and SAVE a 2nd time I cant figure what Im doing wrong but, sometimes, the > nice lady says CONFIRMED instead of rcv or xmit freq I have experimented > with setting OFFSET to OFF, - and +... no joy I checked MIKLOR but found no > info on what Im, specifically, doing incorrectly😢 Ive tried > reversing rcv & xmit freq, adjusting OFFSET to the opposite sign, with > resulting copious tears😜 I am eager to learn how I can be worthy of > an Extra-class license, again! 73Phil, WF3W > > > > ? |