How about rearranging the memory channels so the one you want will be the one it
defaults to instead of trying to tell it to use memory X? Would that be good
enough?
Donald KX8K
On Mon, 16 May 2022 17:03:21 -0700, "Rick Hatton" <doxieguy.71@...> wrote:
On Mon, May 16, 2022 at 01:19 PM, W9BIK wrote:
In CHIRP, select the "settings" tab on the left side of the screen, then
select "work mode settings". There are (should be) two fields labeled "MR
A Channel" and "MR B Channel" . These are the channels the radio will tune
to when power is turned on.
Is possible your version of CHIRP might be different and have those fields
in a different tab, so look around in Chirp if that is the case.
Don't forget to follow proper procedures to upload the file from the radio
first, make your changes, then download back to the radio.
Everything is in the same place. MR A channel is set to 1, MR B channel is set to 4. On start up the radio usually goes to 0, but sometimes some other channel but B goes to 4.
----------------------------------------------------
Some ham radio groups you may be interested in:
/g/ICOM /g/Ham-Antennas/g/HamRadioHelp /g/Baofeng/g/CHIRP
