开云体育

It doesn't display the dashboard even with localhost:1880/ui I went to "allow a program to pass the firewall" and node js is checked so I don't know what else could be blocking it. Charlie

You can load the VITA49 and FlexRadio flows in addition to FRStack. 73 Dave

Works fine for me... It may be an issue with your windows firewall. Worst case, the need to open that port up. Regards Dwayne (310) 849-2036

My 6400 flow is using FRStacks. Charlie

Hi Charlie The first place I would look is to make sure that the Firewall isn’t blocking it. Mike

Has anyone tried installing NodeRed on Windows 10. I did so, and it looks fine, but the dashboard doesn't display when going to xxx.xxx.xxx.xxx:1880/ui. The browser window has "undefined" at the top.

My VITA49 and FlexRadio v6 flows already zero meters for the 6400. 73 Dave

Oy.....sorry you're having such problems. Hope this year brings much better stuff. The newest version of the Flex3000 flow is in my folder here. It's under KB8CR's Folder. I hope I can transfer the

Thanks, I will make a notation in the WiKis to click the Open button in SPE amp dash to start the connection. 73 Dave wo2x Sent: Wednesday, February 24, 2021 1:44 PM To: [email protected]

Hi Dave, Basically I used the rpi imager to burn the 32bit version to sd card, went through the setup as instructed by the imager. I then switched vnc on in raspi-config and cut and pasted your 32bit

Hi Charlie, Please send me your latest flow for the 3000. I want to try to zero the S meter during TX and power meter during RX. I do not have a 3000/5000 but can simulate them for testing the meters.

I have them set to "Rocket" Charlie KB8CR

Check your meter nodes in node red and to see how you have animations set. AL, K0VM

Hi Paul, Thanks for letting us know. I fo have any pointers since it is fresh in your mind please let me know. I can add a SPE section to the WiKis to help the next person. 73 Dave wo2x Sent:

Thanks Alan for the offer, but i finally got it running. I didn't realise that you had to hit the open button on the spe dashboard to get it to read the serial port, it is all now working as it

I wonder if it would be more responsive, if I ran NodeRed on the computer that is running PowerSDR, and use virtual serial ports, rather than the TCP serial server. Right now, I'm running NodeRed on

Dave: Hope you're feeling better. I went out for the first time in a LONG time, to pick my brother up from the airport. Had two masks on.....Fauci would approve.ha ha. I got busy here with business

Paul I cannot help you any further because I lack knowledge of your configuration (virtual here). Perhaps others can comment. Another approach is to build a separate Raspberry Pi SD card dedicated

Virtual here is not running I only used it to check communication with the amp via the pi.. It is not in the equation when running node red or frstack. Paul Gi4fzd

Paul You have introduced new variables, which I cannot comment on all. Your question about opening port 5025. Not sure how that enters into your configuration. Normally, TCP Port 5025 is used by