Re: Frstack running fine until I enable the SPE part
|
Paul
You have introduced new variables, which I cannot comment on all.
Your question about opening port 5025.? Not sure how that enters into your configuration.? Normally, TCP Port 5025 is used by FRstack.? Do you mean opening up port 5025 on your router?? I cannot think of any reason to do so.
How does "Virtual Here" enter into your configuration?? Are the SPE amp and the device running FRStack not connected with a USB cable, or are you using a virtual USB port?? If yes, I cannot help you with that configuration.? Or, perhaps?Virtual Here is causing the USB ports to not work alongside?FRStack using USB ports?? Others can comment on that.
??My responses to you have been based on the SPE amp connected directly to the device running FRStack via USB cable and no other apps using?or configuring the device's USB ports.
Alan?
On Wed, Feb 24, 2021 at 8:29 AM Paul Menown < pako20@...> wrote: I Checked the amp firmware, it has the same date but has B_15s at the end rather than C_15s
the page advises only to update if the date is earlier so I am reluctant to update.
Not sure if that would have an impact.
Also do i need to port forward 5025 to the pi, as It just doesn't seem to be reading the usb0 port at all. Although the usb port is working if i connect via virtualhere server on the pi and run the windows client the usb control panel works perfectly.
?Almost no hair left hihi and xyl complaining about the amount of time I have spent on this..
Also I appreciate all the help from the group, mainly yourself and others.
Paul
GI4FZD
|
