¿ªÔÆÌåÓý

ctrl + shift + ? for shortcuts
© 2025 Groups.io

Re: Frstack running fine until I enable the SPE part


 

¿ªÔÆÌåÓý

Thanks,

?

I will make a notation in the WiKis to click the Open button in SPE amp dash to start the connection.

?

73

Dave wo2x

?

?

From: [email protected] <[email protected]> On Behalf Of Paul Menown
Sent: Wednesday, February 24, 2021 1:44 PM
To: [email protected]
Subject: Re: [nodered-hamradio] Frstack running fine until I enable the SPE part

?

Hi Dave,
Basically I used the rpi imager to burn the 32bit version to sd card, went through the setup as instructed by the imager. I then switched vnc on in raspi-config and cut and pasted your 32bit wiki instructions for installing nodered and frstackwebapi.
I used Marks new version?
I set them up to run as a service. I then edited the appsettings.json using nano at the line regarding SPEComPort? i followed the recommendation that you advised (?paste in the path to the "by-id" link of the FTDI cable.

?

This is what my FTDI cable looks like.? Your FTDI cable number will be different.

?

/dev/serial/by-id/usb-FTDI_UT232R_FT44JLEC-if00-port0? ?)
Then I loaded the modules in your text file,

node-red-contrib-msg-resend?

node-red-contrib-ui-led?

node-red-contrib-ui-level?

node-red-dashboard?

node-red-node-wol

node-red-contrib-string

then rebooted the pi.
I then loaded the frstackNodeRedV107.json from the FRStackWebApiRPi_3_1_27_56.zip file ,enabled the SPE AMP flow and it worked.
You do need to press the Open button on the SPE dashboard to get the info from the Amp. (I think missing this point was my main problem)
That is about it
Cheers
Paul
GI4FZD

Join [email protected] to automatically receive all group messages.