开云体育

It ain’t. http://pilloud.net/op_web/one_port.pdf Ed McCann AG6CX

It ain’t. http://pilloud.net/op_web/one_port.pdf Ed McCann AG6CX

Also recently purchased from AURSINC (a -H) and all was as expected. Tim K1BR wrote:

I recall when first setting up my nano vna to use the pc based options, being stuck in the wrong driver loop.?Windows would insist that it had the best driver loaded if I attempted to to an update

The user manual states that it is the | S11 |. I think that "Linear" is a bit of a misnomer, but it is what it is until it ain't. ~R~

I have had good experiences with several purchases from AURSINC. -H, -H4, RF Demo Kit, etc. I have purchased from them for 2 years. ~R~

Linear simply means the conversion of dB to linear units. i.e. 10^(dB/10) or maybe 10^(dBV/20) Gary W9TD

Wading through file I have not been able to find what variables "Linear" and "SWR Linear" mean. Looking at formulas on the spreadsheet, "Linear" ( Column G) contains the absolute value (magnitude) of

Maybe you have a wrong Windows 10 driver. You have to start NanoVNA in DFU Mode. After connected, you have to see it as "STM Device in DFU Mode" in Controller USB (Device Manager). The right driver

I would like to purchase a later version of the nanoVNA. Which vendor does everyone recommend that has the latest? thanks Vince

I believe the bootloader device is correctin dfu mode . . . dfu is definitely different than "normal" run mode that is a COM device. -- Sent from my Android device with K-9 Mail. Please excuse my

Thanks for all the info. It currently works well for what I'm doing...so i might leave well enough alone. Not worried about doing firmware upgrades, my rigs get regular updates.. did have a bit of an

There is a special DFU driver required when you want to update the firmware using DFUSe demo or NanoVNA app. When you install DFUSe demo this driver gets installed. When you put the NanoVNA in to DFU

The first (simplest) thing I'd check is the USB to USB-C cable. The one I got with my NanoVNA was bad. I bought one from a reputable source and it worked. Zack [email protected]> wrote:

What NanoVNA are you using? [email protected]> wrote:

When the H4 first came out the case was too tight and pinched the screen. Then touch input was erratic. Try loosening the case screws and see if that works. If it works you can open the case and

Have you tied Clear Config? Roger

Hello I have a H4 (HW Rev. 4.2). I read the newbie stuff and i think i understand the fundamentals. (I also read Dislords firmware update notes) When i got it, the firmware was 1.0.39. I installed the

@Rich: as it has been discussed off line - in case the Cable calculation (phase method) depends on the velocity factor and the exact frequency of the phase jump only, the limiting the freq range

I bought this for Christmas abut 1 1/2 years but was too busy to learn how to use it. I got it out today after my new TinySA arrived today, and tried to learn a few things. But the Control Knob will