开云体育

Any chance you can add the option of rotating the display graphics 180 deg? I can see the cables coming out of the bottom being a nuisance in some instances. And please get rid of that ridiculous

You are correct Alan, I was too hasty in my enthusiasm.? And when the result is pure resistance there is resonance.? At frequencies above self resonance an inductor acts as a capacitor. Which

I would also like to add my voice to the many that would want to purchase this with a larger screen. How does the larger screen you may or may note use compare with the 4.3" on the NanoVNA-F? The 4.3"

However, the result of distributive C for an inductor which is one appropriate model, shunt C, leads to an inductor value which INCREASES as we approach SRF. The arithmetic for this is; Xt=

Thanks Bob. I'll give it a go. Martin K0BXB [email protected]> wrote:

On Tue, Dec 17, 2019 at 10:40 AM, Dale Parfitt wrote: Thank you Herb, So much traffic, I missed the specs. ==================================================== Dale, I'd like to add a correction

Roger, it's really very easy to make your own cables. There are SMA connectors that use the 'solder the center' and 'crimp the shield' type of construction. I use this method on all my connectors,

One addendum regarding inductance.? I did mention that 50 kHz as a low limit prevents measurement of large inductances. I just measured a few and got good results up to around 50 mH.? My inductance

I have read numerous comments that state that the quality of the cables supplied with the NanoVNA is poor. However Hugen has supplied good calibration terminators in his NanoVNA-H in the gift box

@Gary O'Neil, N3GO - 17 December 2019 /g/nanovna-users/message/8320 - O K ! -

Great stuff. Sorry if this has been answered elsewhere but are there plans for Bluetooth? Thanks, Brian WB8AM

Thank you Herb, So much traffic, I missed the specs. Dale W4OP

On Tue, Dec 17, 2019 at 10:10 AM, Dale Parfitt wrote: How does this differ from the 4.3" NanoVNA-F already available? ==================================================================== Recapping

On Tue, Dec 17, 2019 at 05:20 AM, Dr. David Kirkby, Kirkby Microwave Ltd wrote: With a well written specification, following closely the format of a major VNA manufacturer like Keysight, some users

How to measure inductance?? Very simple.? First, you make up an adapter so you can connect the unknown to the nano S0. Calibrate the nano.? The next step depends on the inductance.? Select a

How does this differ from the 4.3" NanoVNA-F already available? Tnx, Dale W4OP

Just another voice asking for a large screen version -- I would really like that! Thanks for all you're doing! John ----

Good job, perhaps offer the option to rotate display 180 degrees so connectors and jog switch point away from user.

Nice job! I can't wait to get one, I could really use one for BLE antenna development. Can I be a beta tester? Op 17-12-2019 om 15:32 schreef Gabriel Tenma White:

I wish you had chosen an alternate location for the selection switch. Right between the connectors will be awkward to use. It probably would have been better to swap the switch and USB connector