开云体育

How does this differ from the 4.3" NanoVNA-F already available? Tnx, Dale W4OP

Just another voice asking for a large screen version -- I would really like that! Thanks for all you're doing! John ----

Good job, perhaps offer the option to rotate display 180 degrees so connectors and jog switch point away from user.

Nice job! I can't wait to get one, I could really use one for BLE antenna development. Can I be a beta tester? Op 17-12-2019 om 15:32 schreef Gabriel Tenma White:

I wish you had chosen an alternate location for the selection switch. Right between the connectors will be awkward to use. It probably would have been better to swap the switch and USB connector

Looks good. What is the lowest frequency you can set the unit to? Sam W3OHM

Ouch, the toggle switch between the outputs? Inconvenient to say at least. I would hope you find a better switch than this one it is to easy damaged especially in the position it is in. Will you be

Good morning GIN&PEZ; To the extent that I can contribute in some positive manner, I am certainly willing to do so under the careful scrutiny of your editorial council to prevent propagating

I would strongly advise purchasing for Hugen's site: <https://www.alibaba.com/product-detail/Hugen-NanoVNA-H-New-item-Original_62342877955.html> I haven't had any issues ordering form the alababa site

From: Gabriel Tenma White Subject: [nanovna-users] First PCB pictures of the V2 Here are the final pre-production prototypes, and plots showing uncalibrated and calibrated S21 floor. PCB files will be

Shields will only show performance in a RF environment, if your lab is clean, you will not notice anything. So keep the shields in place, please. Going to become a VolksVNA. OE8UWW

I was wondering about that als

There are little sensible specifications on the raw performance. The match at port 1 is significantly better than port 2. As for dynamic range, there should be two figures for that - a system dynamic

Here are the final pre-production prototypes, and plots showing uncalibrated and calibrated S21 floor. PCB files will be released when V2 is available for order. The LCD connector can accept the 4

One thing I do not understand is why connecting the port 1 and 2 grounds together should decrease performance. Shouldn't all grounds be connected together, and all of these grounds to the chassis?

Here are plots before and after calibration.

@Gary O'Neil , N3GO - 17 December 2019 /g/nanovna-users/message/8294 Dear Gary, Your decision is really great. So, would you allow us, please, to ask you if could you reconsider your

I'm pretty sure S11 directivity is a well defined parameter. It is the (uncalibrated) ratio between the |S11| reading when measuring an ideal load and the lowest |S11| reading when measuring loads

If you could produce a set of specifications, in a *format* used by Keysight, then people with the right equipment could compare the performance of one NanoVNA-H against and the specifications, and

/g/nanovna-users/message/4970