开云体育

Hi Paul, if N is an alternative for you: N provides much better accurate quality for higher frequencies than BNC. See pics: The (slightly hot air bent) extended PE board permits hand isolation: Often

/g/nanovna-users/wiki/BNC /g/nanovna-users/wiki/RF-Calibration%2C-considerations%2C-notes

What Linux distribution are you using? As Nick said, if you follow the installation instructions, the program installs without a problem on Linux Mint 19.2 and works just fine.

And your badly written, ungrammatical "thoughts" are not an answer at all! If you have nothing useful to say, please avoid posting noise.

No: https://www.softmaker.net/down/officecomparison_en.pdf

If you want to move a marker, put your finger or stylus on the trace, and without lifting it, drag left or right. The important bit being "without lifting it". If you lift your finger or stylus, you

To check for newer offerings, I go to /g/nanovna-users/wiki .. then search for software .. then firmware

Hi Bob - Unmodified ST-LINK lacks support for communicating with firmware https://electronics.stackexchange.com/questions/321446/is-it-possible-to-use-st-link-usb-for-uart-communication

Why not? But i dont think they wil fit or the case wil be a lot thinker,maybe if you make a printable box around it Op zo 8 dec. 2019 09:30 schreef paul larner <quadzillatech@...>:

seems to me the vna saver is iffy,i get a smith chart with only the trace displayed ie none of the circle markings,its like the trace is in thin air,any ideas?,on my lappy the creed display just

only half an answer as per i see!!,why do ppl bother if only answering half the original question?,beggars belife so many folks on forums do this or go off on a tangent!!,just my thoughts! 73 m3vuv

hi all im thinking of changing from sma to bnc connectors on my vna,maybe mounted on an extender board hooked up to the vna with some small coax,is there any issues with doing this as regards acuracy

Hi Larry, Thanks for the tip Softmaker freeoffice. It has a full visual basic compatibilty with free version? Zplots not work on older excel, libre office and openoffice. Currently write reply from my

I have one more question regarding the NanoVNA Saver software In the TDR display there are two traces, One Red and one blue. I understand the red but not the blue. Would some please give me an

I have one more question regarding the NanoVNA Saver software In the TDR display there are two traces, One Red and one blue. I understand the red but not the blue. Would some please give me an

Good evening all, I have the VNA Saver 0.2.1 software. I like the features and the operation is somewhat intuitive. I do have a couple questions. 1. Is there a newer version of the VNA Saver software?

Sorry Bob but the stlink won't charge the battery as it's connected to the 3v side of the regulator that runs the micro.? On Sat, 7 Dec 2019 at 10:25 PM, Bob Albert via

Don't move the marker by touching it.? Use, instead, the multipurpose rocker control at the top.? Rocking it one way or the other will move the marker in use.? To change markers you go to the menu.

So I just hold it in place and can charge the battery via the ST-LINK?? I don't care about programming at this point but I would like connectivity to a computer.? Holding it in place is another

Have you used a stylus? Fingers are too large for that little screen. *Clyde K. Spencer*