Good evening all,
I have the VNA Saver 0.2.1 software. I like the features and the operation
is somewhat intuitive. I do have a couple questions.
1. Is there a newer version of the VNA Saver software?
2. Reading the user manual posted here It references using the "REAL" mode
when looking at the TDR function. I seem to not be able to find that. I
would really like to get thisworking
3. I am not sure of my NanoVNA firmware but I think it is QRP 0.4.3. Is
there newer firmware?
I appreciate all that respond,
Clyde KD8AN
*Clyde K. Spencer*
toggle quoted message
Show quoted text
On Fri, Dec 6, 2019 at 5:44 AM Gyula Molnar <gyula.ha3hz@...> wrote:
Hi Larry,
I'm glad that many people have noticed what the original author wrote in
the "Know issues" section of the NanoVNA alpha1 kit assembly manual.
I think the same way, thank you for trying to confirm that I'm not trying
in vain.
73, Gyula
On Fri, Dec 6, 2019 at 12:14 AM, Larry Rothman wrote:
Good to know, Bob.
I had suggested to the devs to use 2 LiPo s with a linear 5v Reg to run
the
unit in order to reduce RFI from that charger/inverter chip.
Banggood has a 2S charging board for about $2 that you run off of an 8
to 12v
source. I'm going to look at that setup soon in addition to modding the
bridge and freq source circuits per the discussion on Hugen's GitHub
repo.
CheersLarry
