Sorry Bob but the stlink won't charge the battery as it's connected to the 3v side of the regulator that runs the micro.?
On Sat, 7 Dec 2019 at 10:25 PM, Bob Albert via Groups.Io<bob91343@...> wrote: So I just hold it in place and can charge the battery via the ST-LINK?? I don't care about programming at this point but I would like connectivity to a computer.? Holding it in place is another story.? I already have charging capability so it's just data I need to get.
Bob
toggle quoted message
Show quoted text
On Saturday, December 7, 2019, 02:49:01 AM PST, Gyula Molnar <gyula.ha3hz@...> wrote:
The picture below shows the ST-Link V2 connector to be routed to a pin row. When you use it with one of your fingers, you gently press it when you are programming. No need to solder.
This was the first time I needed this and it worked right away.
The RST cable is not needed here.
73, Gyula HA3HZ
