JPD Borgna wrote:
To attach the zone to a net, you have to first highlight the net with "Resaltar Red", then create the zone.
It would be good to have the posibility, but dont know if that is right at the design of a pcb (to put thermals in a thruhole).
you are right, I wasn't thinking. I actually did have the zone connected to ground. that is why it worked in the end. But, DRC does not recognize the connections unless an actual trace starts from each ground pad, and ends at another. To clarify, a picture of the board is here:
I wanted thermals on the vias because it is a pain to solder (if you don't have soldermask). You can see there, that ground pads of each module have thermals, but the vias do not. My professor actually commented on my lack of thermals on the vias.
-ryan
