开云体育

Hi Dan

I deleted all board outline and put it in again and it worked.
Thanks for your help.
Richard

On 13.06.2012 15:41, Dan Andersson wrote:

Richard,

Magnify your design and look for unconnected "dots" or very very short
tracks.

This happens sometimes when you have an undeleted track segment left.
These track segments can be extremely small and almost invisible -
still annoying thop'.

This is only a problem when exporting for auto routing.

//Dan, M0DFI

On Wed, 13 Jun 2012 13:03:37 -0000
"richardhaldemann" <r-haldemann@... <mailto:r-haldemann%40ggs.ch>>
wrote:

Hi all
I have successfully created a schematics including all libs for

schema and footprints then placed the components on a board. Then I
tried the manual router but as my board is quite dense I could not
route it. I think the manual editing of PCB boards is not very
comfortable.

So I decided to extract the specctra DSN but could not create that file.
I get the following message (translated from German) IO_ERROR: Can

not find next segment with end point @ ( 90.424mm,62.738mm). Please
adjust the board outline so that it is connected/continuous. then some
path ...pcbnew/specctra.cpp: ThrowIOError() : line 119 Export not
possible. Please solve the problem and try again.

I have redrawn the pcb outline several times. I have started the

line in a different corner every time. It seems as if the start and
end of the line are causing a problem although I put the line on a grid.

What can I further try.
Regards
Richard