Re: No SSB output
¿ªÔÆÌåÓýI¡¯m not sure if this part was clear¡ but you should have jumper wires that go from the 90 degree pins on the MAIN board next to the processor up to the appropriate pins on the hat per the schematic (eg there is no other connection to those hat pins thru the Teensy).? I¡¯m driving so can¡¯t take a pic.? Someone else may be able to post. ? If you got this right, please ignore. ? ? Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ VP2EHZ ? Owner - Operator Big Signal Ranch ¨C K9ZC Staunton, Illinois ? Owner ¨C Operator Villa Grand Piton ¨C J68HZ Soufriere, St. Lucia W.I. Rent it: ? Moderator: North American QRO Group at Groups.IO. Moderator: Amateur Radio Builders Group at Groups.IO. ? email:? bill@... ? ? From: [email protected] <[email protected]> On Behalf Of Tim via groups.io
Sent: Thursday, April 17, 2025 1:10 PM To: [email protected] Subject: Re: [SoftwareControlledHamRadio] No SSB output ? I have been hooking up to the pins Iq out on main board, the ones we installed with rt angle pins. I will also try this connector. Tim ? |
K9HZ