开云体育

Steve, apologies - its been so long since I released version 7 ... and now retired - I forget to ask that question! Which version are you using. Now that stated your symptoms do not suggest an issue

Mike, Its been a loooong time since I used or tried EasyTrack - but I'm pretty sure that the DSC connected will not allow it to work. Was the DSC light blinking slowly when you did this? If you heard

Have you setup the Latitude correctly in the configure? [email protected]> wrote:

My AZ encoders don't pick up the swing on the trunnions when I change directions in ALT, so I need to clear that slop.? I always align on stars, so I make the final approach in the same direction as

Thanks for the responses. ?I’ve requested the required files and will do the updates and will report back. Steve

My "Dead CAT" thread has digressed to a conversation about EasyTrack mode so I thought I'd start a new thread: From the SC documentation (bold is my addition), to enable EasyTrack operation: With the

Steve try updating the Servocat to V7 with the Nexus update included, you will need to contact Bill, and contact serge at Astro devices for the newest Nexus upodate. Tell Serge, Mickey sent you for

Hi Gary, Yes , i agree, this is why I was writing : " Anyway, now the highest challenge is to improve the pointing as you and Sevan Aydin described. I have to dedicate a several hours to make a

Hi Steven - long time - hope all is well. Ok - so first are you sure the parameters, the ratio and the track/goto directions are correct? For the directions you can do this simple test. With the scope

Raphael, Good morning sir. So - first just to be sure - you don't "put" anything in - you go to an object - then move away in AZ (for the AZ test, later in ALT for the ALT test) ... 100 degrees is a

I have a ServoCAT fitted on a 18 inch Starmaster scope with a Nexus DSC. ?I have been having the scope drift off target fairly consistently, lately. ?I have tried realignment and cycling the power

Thanks Gary for all this. In fact I have already used the Backlash Optimization file and found a backlash between 2 and 3 arcmin. I didn't know that removing backlash was very important during the 2

Mike: please see my post of today! Again: if the DSC is connected - and if you heard the beeps it was - you will never go in to EasyTrack! g.

Thanks, Bill - I've got the manual.? I was just wondering if the SPm LED should stay on after releasing the CCW button on the HC.? After enabling EasyTrack I wasn't seeing any movement in AZ or ALT,

and let me add - critical point - you said you hear the 3 beeps - that is the Argo! The manual (I am pretty sure or I messed up) specifically says you MUST have the DSC cable unplugged at the front of

Raphael, Good morning sir. So backlash. Backlash should be compensated for. It has to be done in situ as it is unique to each scope. It will impact GOTO's in that if the move ends up being in the

Sent email again. BC

Mike...From the ServoCAT Manual... With the scope set to the NCP turn the power off on the ServoCAT. Flip the speed 1/2 switch (on the front panel) to the "2" position (EasyTrack is a SuperProgram

Can you please send again as I believe it went to my spam folder which was deleted. Thanks Mike

Hi Mike. I have responded to you via email. BC