开云体育

Am I getting EasyTrack enabled.... With the Speed switch set to 2, holding down the CCW button on the HC (I have a Dob), and powering on, I see the SPm light come, but then when I release the CCW

Does anyone know if Bill has any autocal cables for sale? I looked on the website but didn’t see anything and I emailed him about a week ago but didn’t ever get a response. mike

Thanks Gary, clear ! I then understand that, even if scope is in its 5 s deceleration phase, I will be able to see it stopping briefly and then restarting I will redo the test as you describe. Maybe

Raphael, The system is designed to do the GOTO until the object offset is less than a certain factor... I think it was like 0.03 degrees or so. So it does one GOTO - checks the offset with the AN -

Dear Sevan Aydin, Thanks for your so complete and inspiring answer. * I can't disengage az drive quickly but I could ask friends to do => we will try to do your technic. Thanks. * got your point

Then Sevan Aydin added : That's a fabulous scope for ISS tracking.? My 15" UC has about the same eyepiece height, and it works out great for ISS (don't forget about CSS).? You will absolutely have a

Dear all, I create a specific thread for observing satelittes by copying / pasting? some exchange that was done in /g/ServoCAT/topic/autocal_cable_length/106277132 My initial message

OK, thanks Gary, I will do as you say. From your message, I understand that, even in deceleration phase, the scope will stop briefly anyway (and then I note the numbers) then restart ? Right ? Thanks

Good monring guys.? Raphael, So - I think your chosen method to do the simple alignment might be the issue with the fact that it didn't finish. I'd just do it as intended and described - under the

Thanks guys ! Wonderfull answers Gary : Before I? adjusted -not perfectly- the ratio like as I described I had tested the "simple track optimization routine" procedure you explained but it didn't

That's a fabulous scope for ISS tracking.? My 15" UC has about the same eyepiece height, and it works out great for ISS (don't forget about CSS).? You will absolutely have a hole around zenith

Raphael, Ok. So the best way to determine ratios is to do the "simple track optimization routine". Ask Bill for a copy of this doc (it is on the CD as well). Basically you'd do a goto to an object and

Hi gary, No translation issue, it is with a 36" dob. Enclosed a picture. Yes, looking the star "flying" was amazing? ! and you see ISS enlarging little by little, see the solar panels as it comes

Rapheal, If you are close on the ratios an AutoCAL will not help with what you're trying to do. It is running closed loop and the ServoCAT is aggressive (high gain) in order to keep up ... BUT the AN

3D pieces received! looks great ! Thanks Mike for having shared this !!! raphael

Dear all After having updated servocat to version 7 and ArgoNavis to version 3.04. I have for the first time succesfully? observed ISS with AN/servocat . Ssssooooo happy ! I have made some

ok. So - remind me (sorry - replied to email and not the thread on the group) ... did you change out the motor encoder cable? Maybe replace that. If its not that then one thing I would see

Both the AZ and ALT motors work as expected using the HC, at all slew speeds. My problem is (way maybe) intermitted, it would start slewing in AZ (clockwise) on its own, with nobody touching

And you're sure you were seeing the red DSC light flashing for this whole time? Does the AZ motor work if you use the HC to slew it? I'd just stuck with this as the test. g.