开云体育

Hi Howard is it possible to run 2 instances of HRI Visual Studio on one Win7 computer? I am presently using 2 computers to control an IC M710 and an IC M710RT with HRI Visual Studio. Thanks Tom KC1GTU

OK, Good to see that is working on de CLONE port. I use the D-sub because there is also audio in and audio out on this connector. It uses two 600 Ohm transformers to make a connection to a cheap usb

Hi, dear Rene, Thanks for your reply. 1) COM ports are correct. 2) I set the COM port number on the set menu of the radio. All are the same. 3) D-sub is set on the set menu. I use DSC out at the back

Can someone please help me with IC-M802 connection as well. I am using a CH340G USB<>Serial interface with flow control to connect with M802 , The Software says its connected buy when I monitor the

Hi Kaan, I checked the Icom IC M710 address , its 01, not 02, but 00 works on all models. http://www.docksideradio.com/Icom%20Radio%20Hex%20Addresses.htm 73, Rene, PA7R

Hi Kaan, 1) Have you selected the right COM port number in HRI?, check with Computer management, Device Manager, Ports,COM port number 2) Choose address 00 ( works with M700 Pro, M710, and M710 RT or

hi there! I have M710 and there are two serial out on back. I connect my pl2303 based usb to serial cable to the dsc out and run HRI software. I set the radio address as what is shown in the set menu

No, NO flow control is added in the latest software. Unfotunately, I am just not able to get my IC-M802 to communicate with the PC. I am using a CH340G with Flow Control PCB for the control Cable.

I am not sure when Flow Control was added. In Settings Window, Radio, there is "No Flow Control" which can be changed to "RTS/CTS" if your radio needs it. This flow control settings appears to only be

Also I am using the March 17 2017 test version of HRI Visual Studio with an IC M710.

I am running the HRI Windows Visual Studio version with an IC M710. Howard N3ZH worked with the Russian guy in previous topics on this group to get the HRI Windows Visual Studio version working with

Thanks Tom, I'll check this up. You have given me hopes. Just one querry ? are you using it with a Serial to USB interface ? Charudatt - vu2upx

Thank you for the response. I think for now I will stick with my emulation approach, where I set-up fldigi to Ray 152, then use Python to do the conversion. After spending a couple of nights tweaking

You might have better luck looking at old posts on the yahoo group.

Hi Charudatt Check the topics in this group from March 17 2017 and back to the beginning. Your IC M802 is rs232 with flow control. I am using the Windows Visual Studios version of HRI Good luck Tom

Hello Aiko Love del Rosario That IC M710 DB9 Remote port is not an RS232 port. It passes Rs 422 data and modulation and Rx audio signals. You would be better off buying a USB to clone pin programming

Hi Tom, I do not know anything about Vara. Looking at the author's website https://rosmodem.wordpress.com/ It appears that Vara is used by RMS Express. RMS Express is a very good free software product

Hi Howard I have been enjoying using HRI. Have you considered adding VARA Soundcard TNC P2P capability to HRI? Thanks Tom Watt KC1GTU

I am also trying to communicate my IC-M802 with the computer, any information will be of great help to me. Thank you. charudatt

Vassill, I can see the possibility of adding the SEA-235 radio to the visual studio version of HRI. I would feel better if there were dozens of people asking for it. Adding a radio which I do not own