开云体育

Nattyone960 thank you for bring this up. Can you or someone else explain to me the difference between an inrunner and an outrunner? Which would be best for a spindle? Mike wrote: the the by a would

I verified both of your suggestions Art (step/dir selected, and laser mode not selected). Still no spindle, but everything else is fine so far. I keep checking back in M2 and all is well there. Would

if that of

SetMacroTrigger() like The 301 will bit of a fully Can I assume that the above process is limited to one custom button? I don't know if it would work but having a stored parameter for a button such as

Eric: The on-board video could be the issue. Do you have a cheap plugin card that can be tested? If so, make sure you turn off the old on in the bios.. Thanks, Art www.artofcnc.ca Videos And Support

Peter: Yes, probably worth a try.. I cant think why it wont display on yours.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users Map:

Scott: In the spindle setup make sure you dont have Laser Mode checked, and make sure Step/dir motor is checked.. Thanks, Art www.artofcnc.ca Videos And Support Forums http://www.machsupport.com Users

Steve: Putting it in the X DRO will set the G54 offset, normal zeroing. Puttin it in Part zero, will store it so the PartZero button can modify the tool length.. Thanks, Art www.artofcnc.ca Videos And

Rich Crook wrote: That is the one :( Kurt's new closed loop system does not like it one bit, skips things and then runs on. Since I'm about to start supporting them in Europe I need to get to the

I am not a expert but outrunners need escs. The brused motor can use the traditonal Speed Controllers. than

Hello, I'm a brand new member here, so forgive me if I've missed the point of this discussion completely! (It wouldn't be the first time...!) It wouldn't be as elegant a solution, but why not just use

I've also got a Taig machine, and have a similar effect from the PC I built to run it... The steppers "stutter" slightly, causing them to stall very easily. I have a distinct jump in th

Gents I bought a connector for the Powermax 1000 machine interface and have it installed. Just thought I'd pass on the part numbers that I used. Per my previous posting, I was not sure I had the

<apalais@...> wrote: check still again? Maybe MP1000-THC Screen Sets will not work with THC300. There are whole sections for the THC interface that will be inoperable.

Hi Hugh, Thanks for your reply. You have answered al my questions. Many years ago when I was playing around with RC cars, the Speed controller I used was an OS 19 motor. Messier than an EMC but a lot

You are right about the BEC and the ability to setup the controllers in any fashion. wrote: throttle, or are the is servo, that it >

Art, The generated pulses ARE good! :-))) My mistake when testing it on a RC-servo was that I attached it to a separate 4.8V battery! When I use the 5 V from the PC it works!! For now I only have 9

Art, I have tried the 1024.set and it comes out fine. You also said to check that the toolpath display box was checked, I have done that and it still makes no difference. Should I download the screen

Hello All, I purchased 2 CGI Precision gearboxes, a while ago and probably will never get to the project I had in mind for them so I am offering them up for sale to a good home. The gearboxes are NEMA

Yup done that Art. But tell me whats the difference between putting the number in the Part zero offset dro and putting it staight in the X axis dro? (when on part co-ords)