Setting up the VFD may be problematic. It will not hurt the motor for short spins.
From: "Spencer Chase lists@... [mach1mach2cnc]"
To: mach1mach2cnc@...
i got my motor and had the mill head bored to accept it. all is
ready to test. i have the Huanyang 110 volt inverter that came with
the instructions for the 220 volt input version. should not be much
difference but i am still a little hesitant to hook it up and
destroy things. i have an 800 watt motor, water cooled.
any recommendations on setting that might be critical? i did get a
manual but it is very difficult to digest. it sort of looks like
factory defaults might be OK. the manual has all the details but no
quick start guide.
is there any risk in running it for a minute or two without cooling?
i would like to bench test it before hooking up the pump and water
supply.
?
and you will then be completely au fait
with all aspects of the VFD etc
--
Best regards, Spencer Chase
67550-Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
(425) 791-0309
