Marcus,
I have one of the following motors that i bought but never used.
Would that make a decent substitute? I have Gecko servomotor drivers
to run it and plenty of toroidal transformers to make power
supplies.
On 3/8/2015 3:55 AM,
m.wg@...
[mach1mach2cnc] wrote:
?
Hi Spencer
I am not certain of the
motor used on your Emco, but the PM 180v DC 4000rpm is
the same as on the F1 milling machine
intended for working with
steel so lower max spindle rpm of 2000, achieved by
pulleys and belt but with reduction rather than increase
as on the F1 Woodworker.
Original makers were either
KEMO (with ZME 200-278 or without ZME 200-285 external
fan cooling) or BAUMULLER ZME 200-290
The ZME part numbers refer
to original replacement brushes.
?
Changing to a router type
spindle may be the answer but there will be LOTS more
noise.
?
Marcus
?
?
--
Best regards, Spencer Chase
67550-Bell Springs Rd.
Garberville, CA 95542 Postal service only.
Laytonville, CA 95454 UPS only.
Spencer@...
(425) 791-0309
