You need something that will handle at LEAST 8 amps (so it'll run cool) and
at least 600 volts.
The OEM's are marked as 1000 volts 10 amps - 8amps at 1000 will do as will
10 at 800 .... GIve me a yell if you have trouble finding one. IF you'll
send me a the board number, I'll tell you what the original was.
Jim RabidWolf
Uncle Rabid ( )
We Repair Electronic Speed Controllers
For Asian Mini Lathes and Mini Mills
"Just Crazy Enough To Get the Job Done"
(Join Rabid's Lathe/Mill Controller/Mod's List!)
(Also visit BarStockEngines - join us in building without Castings!)
toggle quoted message
Show quoted text
----- Original Message -----
From: "Alan Reeves" <goatfarm@...>
To: <7x12minilathe@...>
Sent: Tuesday, April 03, 2007 6:17 PM
Subject: [7x12minilathe] Mini-lathe controller rectifier question
I have a Homier Mini-lathe with a shorted bridged rectifier. I
removed the rectifier to see if I could buy another and have lost the
darn thing. Does anyone know the part number? I had a rectifier on
order but when it came it, it did not look like the old one. Also,
the rectifier is in the lower left of the circuit board when looking
at that side, which way was the flat on the rectifier? I seem to
remember it was up and to the left. Any help would be appreciated.
Thanks
Alan
Be sure to check out for small mills and
lathes.
Yahoo! Groups Links
