On Fri, 21 Jan 2022, Miket_NYC wrote:
I assume it mounts horizontally now, right? If so, no need to hack it. Just put it on an angle plate.
On Fri, Jan 21, 2022, 10:14 AM fxkl47BF via groups.io <fxkl47BF@...> wrote:
I recently acquired a Palmgren 800 rotary table for a faction of this cost.
I would like to modify it to mount horizontally or vertically on a small mill.
I'm open to suggestion before I start hacking.
Thanks
As the flier in the add shows it was made to mount on the toolpost of a lathe.
I could mount it vertically with a couple of 123 blocks but not very steady.
If I put it on a large angle plate I would not have enough room between it
and the mill spindle.
