Re: rotary table re-engineeering
|
Strange that you asked this on a Mini Lathe group. I had a discussion last year about doing exactly this turn out getting a large 90¡ã angle piece to mount the rotary table to? was the best solution. Of course this is a pain if you want to use the table horizontally as it has to be unbolted from the angle piece.? Ralph
I recently acquired a Palmgren 800 rotary table for a faction of this cost.
I would like to modify it to mount horizontally or vertically on a small mill.
I'm open to suggestion before I start hacking.
Thanks
|
