??? ??? Just watched this last night . It may work for your
problem .
??? ???
??? ??? animal
On 1/14/2022 2:21 AM, drmico60 via
groups.io wrote:
toggle quoted message
Show quoted text
Hi Tom,
I have tried your suggestion 3 and the problem is that the drill
cuts the epoxy much faster than the steel and this forces the
drill bit to follow the original hole. The best way I have found
is to fill the holes with some steel screw threaded bar leaving a
little protruding. Put some epoxy on the screw thread when fitting
the screw. Allow the epoxy to set and then file the steel flush
with the surface. Centre punch the new hole position and re drill
the hole.
Mike
