开云体育

Really looks like I must have an other HID device on my system that "likes not" the SO2R box connection.

How could I figure out ?what it is??

Markku

---

From:?[email protected] <[email protected]> on behalf of Markku Oksanen <markku.a.oksanen@...>
Sent:?Wednesday, September 25, 2024 5:44 PM
To:?[email protected] <[email protected]>
Subject:?Re: [yccc-so2r] SO2R box utility bug

?

Hi

Just turned things OFF.

Did verbose

However the SW is not supporting copy/paste for this email.

Is there a log to send?

Click RX R2, TX R2.

Click Stereo

HOWever, I see that one OTHER SW on my setup sees a glitch with recovery for that HW and all is well afterwards.

This is a interface card by velleman.

Perhaps this is a particular local issue.

Is there a way to make sure the the HID devices for sure have different addrs/whatever??

Markku

---

From:?[email protected] <[email protected]> on behalf of Paul Young <k1xm@...>
Sent:?Wednesday, September 25, 2024 5:27 PM
To:?[email protected] <[email protected]>
Subject:?Re: [yccc-so2r] SO2R box utility bug

?

I just tried the same steps and it worked with my SO2R Box.? I am running the same utility and firmware versions.

Could you click verbose Output on the SO2R Box Utility and then try those steps agan?? You can send the output directly to me rather than to the group.

??? Paul, K1XM

On Wed, Sep 25, 2024 at 10:18?AM Markku Oksanen <markku.a.oksanen@...> wrote:

Hi Paul,

Well this is what IT support should look?like ?:

I am using firmware 1.6.0 and the utility says version 1.8.0.

I just did the reset, it says

Device removed

Device attached

And when I click "connect" I get connected + SO2R box version 1.6.0.

I click on RX Radio 2

TX Radio 2

Then click Stereo.

I get Device removed.

Trying "connect" says Not Connected.

Turning the HW off allows me to get the Connected SO2RBox Version 2..6.-0.

I changed a bit of wiring such that my remote AC switch turns off ALSO this box, so I am OK for now.

Thanks!

Markku