Hi all,
How do you seal screws which penetrate the buoyancy tanks (in a Wanderer Mark 2)? This applies to eg the screws for the swivel plates for the floorboards and the screws at the bottom of the tabernacle. I have a couple of screws which are loose in the fibreglass and leak air / water. Can anyone advise on the best way to recreate a seal? I was thinking about removing the screw, squeezing in some gelcoat and then re-drilling, would this work, and should i also use some sealant?
Very grateful for any views.
thanks
James
The Marine Management Organisation (MMO) The information contained in this communication is intended for the named recipient(s) only. If you have received this message in error, you are hereby notified that any disclosure, copying, distribution or taking action in reliance of the content is strictly prohibited and may be unlawful. Whilst this email and associated attachments will have been checked for known viruses whilst within MMO systems, we can accept no responsibility once it has left our systems. Communications on the MMO's computer systems may be monitored and/or recorded to secure the effective operation of the system and for other lawful purposes.
