开云体育

And one more important question: is that need any special device to build the kit? I mean: signal generator, oscilloscope, ...? Thanks again, 73 Ervin

Hi Alan, thanks for the reply, the 8.83MHz IF is the 2nd in TS850, and as I know, that's before the filters - so, I hope that's a wide band output. The Kenwood had been manufactured for this RIG's the

Original Message ----- Subject: [softrock40] Info about SoftRock Lite II for IF monitoring Ervin, I cannot say exactly but a Google indicates that the 8.83MHz IF before the roofing filter is available

A quick way to know if the RXTX is being keyed by the PTT signal is to measure the voltage on the hairpin of R35. The is the "S12" signal and it will be 0 volts in receive mode and 12V in transmit.

Your setup sounds like it is connected in a way that should work. But I am not clear if you have setup Rocky correctly. On the Settings/Audio screen I/Q Input Device should be set to the Line In of

Stereo card?

John Stockman,KC2THY authored the starting message in this thread.

I have almost completed an Ensemble RXTX., All the voltage tests in the WB5RVZ documentation have checked out out until I tested the power output at the BNC jack. I am only getting voltages using an

Then you need to figure out how to select the correct soundcard input to be used by HDSDR. There are 2 places to look at : 1. Windows sound mixer settings 2. HDSDR "Soundcard" and "Options" menus. 73,

Thank you Lee! Best Regards, Chris Wilson. 2E0ILY (UK)

Hello OM's, I'm new on this list - and I'm a recurrent HAM :). I have a Kenwood TS850, and I would like to see the 2nd IF spectrum. Can I do that with SoftRock Lite II? What should I need to order

Yes, when I remove 12v, I get that pattern, then when I remove USB, I still get the same pattern.

Do you see the same patterns when you power down the Softrock? 73, Mike

When I run HDSDR and try to receive with the rxtx, I receive the pattern shown in the image, no matter what frequency I am on. Help!

Sorry, too fast here is the site https://sites.google.com/site/hardrock50beta/home/hardrock-50-builder-s-portals/sn1200-and-up-builder-s-portal Lee

Go to this site...it's on the left side down the page. This is the site where you should be for build instructions. Lee

Before you guys disappear could one of you post a full link to the "Hardrock" forum please, I'd like to enrol. Thanks. Best Regards, Chris Wilson. 2E0ILY (UK)

Hi Lee, In the process of moving the 3 pin Molex from the amp Board to the Driver. It got lost. Email me you address and I'lll send you one. (jcveatch1 at gmail dot com). As for the wiring, the pin

Hi! Have you already seen it? http://18004school.com/vp/breakingnews.php --- This email is free from viruses and malware because avast! Antivirus protection is active. http://www.avast.com

Jim, OK, I have the driver done...except I still have a free end of the 3 conductor power cable. I do have a 3 position molex with 3 pins for it. How do I wire the power cable? I looked everywhere and