Re: Newbie Error? #pcbgcode
¿ªÔÆÌåÓýHi Bruce ? Thanks very much for the reply. ? It seems to be solved and something to do with the GND polygon. I deleted the polygon that was there- redid it and it was back to how I intended.. ? All very strange for a beginner. A simple board has taken me hours and hours to get this far. For me, Eagle is a very steep learning curve. ? Regards ? Barry ? From: [email protected] <[email protected]> On Behalf Of bruce q via groups.io
Sent: 09 January 2022 14:51 To: [email protected] Subject: Re: [pcbgcode] Newbie Error? #pcbgcode ?
On Sunday, January 9, 2022, 04:50:43 AM PST, bullstreetboy <2e0ide@...> wrote: ? ? Hi Guys ? This is my first attempt at using Eagle and PCB_Gcode. ? I have a very simple 12 keypad with smt resistor network. ? All was going well and Eagle looks good with top layer as expected with tracks /pads/resistors etc. Bottom just had Key pads as expected. All looks good in Eagle Manufacturing with top/bottom layers as expected. ? The first few runs ?of PCB_Gcode did as expected but now on the bottom layer I¡¯m getting an exact ?mirror of the top layer. I¡¯m getting the tracks etc instead of just the pads. ? I¡¯ve checked and rechecked everything that I can think of to no avail. ? It¡¯s almost certainly a newbie error! ? An advice much appreciated. ? Regards ? Barry ? |
bullstreetboy