Hi Guys
?
This is my first attempt at using Eagle and PCB_Gcode.
?
I have a very simple 12 keypad with smt resistor network.
?
All was going well and Eagle looks good with top layer as expected with tracks /pads/resistors etc. Bottom just had Key pads as expected. All looks good in Eagle Manufacturing with top/bottom layers as expected.
?
The first few runs ?of PCB_Gcode did as expected but now on the bottom layer I¡¯m getting an exact ?mirror of the top layer. I¡¯m getting the tracks etc instead of just the pads.
?
I¡¯ve checked and rechecked everything that I can think of to no avail.
?
It¡¯s almost certainly a newbie error!
?
An advice much appreciated.
?
Regards
?
Barry
?
bullstreetboy