Hi
Well thats good to know i got something right !!
I have amended the file as you have suggested
but now when i run pcbgcode in eagle it gives
me a few popups saying the same thing
rack file.../settings/AUX SWITCH BOARD_TEST_3.drl
no drill sub for 0.040000"? 1.016000mm
and i press the button " shutup already " and it carrys
on till it pops up again, think it do that about 3 or 4 times
then it makes the drill file
oh by the way that prob with jaw**.exe not found or working
well i found out it has something to do with preview, turning
it off in the pcbgcode setup stops it showing.
Howard
