Len,
In my experience, the answer is "maybe" LOL
A lot depends on the controller that your using to run the code. Some will do a decent job of starting in the middle of the code (as long as you don't try restarting in a G02 or G03 code. Start it at a G0 or G1).
From what I have read Mach does not like starting in the middle of the code, but YMMV. Best way to find out is do a test run.
Country Bubba
toggle quoted message
Show quoted text
At 9/13/2018 12:14 PM, Leonard Wohlsdorf wrote:
Hi all, I guess I must be asking a unanswerable question. When I am using my gcode in the cnc program can I just rerun a portion of the code again without starting from the beginning? Anyone know if this is possible? Len
