开云体育

Hi Kurt,

Are the small stray lines from measurement curves or from markers? Did you notice any pattern that causes these stray lines? Did you see this with edy555's firmware?

All the above information can help me a lot in identify the source and debug.

Regards,

Ken

Hi, I have upgraded to this latest version. Haven't had time yet to test
for stray lines, but I did notice a minor issue when inputting a
frequency. In any of the modes (start, stop, center and span) after
entering the first digit, the rightmost digit of the previous frequency is
partially visible on the input line. Looks like the input box needs to be
a bit wider.

Keep up the great work.
Keith VK4AKA

On Thu, Feb 20, 2020 at 09:09 PM, Keith N wrote:

"I did notice a minor issue when inputting a frequency. In any of the modes (start, stop, center and span) after
entering the first digit, the rightmost digit of the previous frequency is partially visible on the input line. Looks like the input box needs to be
a bit wider."
==============================================================
Ken,
I have verified Keith's issue regarding the input field (see attachment). As he said the right most digit of the previous frequency value is still visible when you start to enter the new value.

- Herb

On Thu, Feb 20, 2020 at 09:31 PM, hwalker wrote:

" I have verified Keith's issue regarding the input field..."
=================================================

I just upgraded to hugen's 5.0 release for the NanoVNA-H4 and it appears to have successfully merged all Ken's recent releases plus fixes the input field issue. Also, now retains the saved smith chart marker format after power off.

Well worth upgrading to. Thanks to hugen and Ken.

Hi Ken
No it is not from markers. I will study it closer as it may be vertical lines only. I will revert soonest possible
I have another NanoVNA with edy555 firmware I will have a look
Kind regard
Kurt

-----Oprindelig meddelelse-----
Fra: [email protected] <[email protected]> P? vegne af Ken Liao, AA6KL
Sendt: 21. februar 2020 05:23
Til: [email protected]
Emne: Re: [nanovna-users] #nanovna-h4 stops at boot screen

Hi Kurt,

Are the small stray lines from measurement curves or from markers? Did you notice any pattern that causes these stray lines? Did you see this with edy555's firmware?

All the above information can help me a lot in identify the source and debug.

Regards,

Ken