开云体育

I got a '403 forbidden message' at the site you listed. Doug "The difference between stupidity and genius is that genius has its limits." Albert Einstein

RealTerm (https://realterm.sourceforge.io/) is a very powerful free terminal program for Windows.

Paul, The firmware version that you reported for your NanoVNA was 0.2.3-2-g8ac9166. That is the version that I have seen installed on hugen's recently released NanoVNA-H model. Out of the box, in

Thanks for the information. Mike N2MS

Please look at the attached picture, Paul.

Hi everyone, we(NanoVNA-F team) just released the RF Demo Kit Testing tutorial. In general, it may not be detailed enough, but it should be helpful for users(in this nanovna-users group) who purchase

On Tue, Dec 3, 2019 at 07:37 AM, n2msqrp wrote: I want to purshase a bridge. Are there any differences between the green and blue versions?

Michael - I'll be happy to update the sticky wikipage entry/settings if a suitable sample could be sent to me or [email protected] Thanks for your continuing support of and contributions

I like TeraTerm but you can use the latest version of putty as well. https://ttssh2.osdn.jp/index.html.en https://www.chiark.greenend.org.uk/~sgtatham/putty ...Larry

That was a good idea, and I've taken the liberty of setting Larry's edited photo as the cover photo for the group. Should this need to be edited again, please send a replacement to me or

I want to purshase a bridge. Are there any differences between the green and blue versions?

Hello - thanks for the helpful discussion (the part of this thread that discusses new member introductory assistance and navigation) Per Andy's note above/below, I have located the member notices in

can you recomend a good terminal program to use?,im on win7/64bit.

Paul, If you want to ensure you clear out all old calibration data (as well as touchscreen and other data) connect the Nanovna to your PC and access the Console Command interface through a

Question: Did you need to convert a HEX or BIN firmware file to the .dfu format using the STM file manager - or were you able to obtain a .dfu file of the firmware from hugen's github site? The reason

i did that already before i calibrated it,i get the feeling its to do with the range i have issues with is over the 300mhz fundamental frequency of the generator in the nano as on the lower frequencys

In the vna menu tree there is a reset button/function. That clears the cal values.

You can set DFUsedemo to verify the firmware after flashing, did you try that ? If it says the firmware verified ok, than your .dfu file is the same as what has been loaded ! Jos Op 3-12-2019 om 12:39

how do i do that?

Hello Paul I had the same problem recently. What you definitely need to do is resetting the existing Cal values in the memory before saving new data there. In my -Q SW Version I even had to Reset the