开云体育

Hi Tim, brevity did the trick, I was able to get back to life using the left jog and on-off switch. The SAA-2N showed up on the -QT software (on my MacBookPro) and got the prompt to load software.

I guess I need to express my gratitude for allowing me to ACCESS the forum, again. I am still looking for any text form of "menu" symbols AKA "menu dictionary". ( No, I do not desire to be "part of

Still OK Neil Colin MM5AGM

Wow, touchy, ta, ta. Mike C. PS I didn't know engines had ears!!

DFU mode does nothing with the screen . . . Perform the steps to enter it (DFU mode) on your unit, and see if it shows up on USB. -- Sent from my Android device with K-9 Mail. Please excuse my

Hi Tim, I would like to get to any mode, but the device does not respond to any input, button or tap. The screen is white and nothing gets a reaction. bob.c

Yes it is listed under Platform after you enter Config-Version. What I don't know if that is the actual chip on the board or what the developer of the firmware just entered as default text for that

Just out of curiosity, is the processor type listed on a display rather than opening up the unit and looking at the chip? [email protected]> wrote:

According to Hugen (manufacturer of -H4) the latest firmware can run on a STM32F302CCT6. /g/nanovna-users/message/24748 Comparison chart >>

Hello all of you, I was wondering if someone measured the T equivalent circuit of an antenna? So the antenna is seen as having three ports: two going to the two points of say a dipole and the third

Sigi, My cupboard yielded exactly 1 suitable box but, in the event, having a bigger format gets away from the "little and fiddly" form of the nano, as well as accommodating the nice R&S flex patch

A photo please. Doug -- This email has been checked for viruses by Avast antivirus software. https://www.avast.com/antivirus

Hi Colin, is your NanoVNA still working okay? I ask because the one i have (bought off ebay a while ago i think) has now got lines all over the screen and is barely readable. Thanks Neil M7SVH

Nice job.... But i would bot use pl sockets but n sockets cause with v2 plus4 or saa2n i measure also on 13cm... Even at 70cm the n socket is better as pl... Your case is so big it should be easy to

Add sma to n adaptors...can or better should be with flange (others with big nut may work also) ... Screw flange on a sheet metal angled 90 degrees to form end and base plate... And then use thicker

Anne, I realize this is a bit different to the approach you're thinking about but maybe it's of some interest. I "re-packaged" my nanoVNA-F to address some of the issues you mention, and to provide

Excellent idea - combine "rotator plate" ( for stability ) with superglue and Velcro ! I actually was not looking to buy those tiny screws to permanently mount the device onto the plate ... Vaclav

I cut a piece of 1/4 inch plexiglass about 9 inches x 6 put Velcro on the nanovna and cables . It keeps the cables from damaging the connectors. De K8HTB

I have been using VNAs at work since the '80s. Professional "box" VNAs have extensive internal power supply and data line decoupling/shielding and are designed as a system with their

That would depend on the test setup.? Most people, when measuring an antenna, use chokes and/or baluns at various points. In a anechoic chamber situation, like when doing a near field scan (which