开云体育

Hello Dana, I have been running most of the recent releases of NanoVNA-Saver on my iMac under Mojave 10.14.6. I declined the upgrade to Catalina because several of my expensive software purchases

#64 : A further simplification of our [LeastVNA] Hello, Allow us, please, to enhance even more more our [LeastVNA] description, by hiding even more of its internals from The Common User who simply

Good afternoon GIN and PEZ: Briefly; Yes I have read your contiguous report @ https://acomelectronics.com/forum/viewtopic.php?p=1311#p1311 This is much improved and helpful to me; but please

Thanks for the Coilcraft pointer. I wonder about their test jig. My "mickey mouse": * thru cal using resistor divider approximating advertised transformer ratio, - e.g. 47 + 6.2 Ohms # for ~ 9:1

Hi Rudi It was just my sense of humor who got me carried away. You link got me down the memory lane to the NWT4000 I also have. I wrote once a huge manual which suddenly showed up when google'd

I, also, bought the AURSINC unit and am quite happy with it. I don't regret paying a little more as at the time of purchase, they were the only ones I saw that were shielded.

Know what you are buying for a test fixture. Specs for trusted Coilcraft signal baluns (1/4 watt max.) Note how insertion loss will increase with bandwidth. https://www.coilcraft.com/pdfs/wbc.pdf

Mel, sometimes Kurt’s links don’t complete properly, even though all the words are there. Let’s see if this works: http://www.hamcom.dk/VNWA/Comment to the Test Chamber and Measurements above

Hi Mel Please copy from http://.. Until pdf and paste into your URL in a browser. Watch out for the inserted > Then it works Kind regards Kurt -----Oprindelig meddelelse----- Fra:

Hello Kurt, Thank you for the detailed analysis. I do not want to tune the nanoVNA to a competitor of a HP VNA. I just want to make the best out of it with little effort, finding the weak spots and

Hi Urrich I think it is worth mentioning that only when a toroid/clamp is measured in a closed chamber the true charcteristics of the material is measured. Using an open air loop you are "fooling

Sorry the link does not open??? Mel, K6KBE

Hi Rune, Many thanks for this new version. I can't comment on the improvements as this is the first version that I have tested, but so far it's working well. I have pushed a new package for

Thanks for the info. I'm new to gnuplot and WSL (and NanoVNA for that matter), so didn't know about the X Windows capability in WSL. Will have to try it. Roman

Hi Ulrich First of all I give you the link to another document not published but in small "circles" and it will interest you I am sure http://www.hamcom.dk/VNWA/Comment to the Test Chamber and

Hello, Let's say I want to use another display with an incompatible controller, does just the ili9341.c file need to be changed? Will it be just a drop-in replacement?

#63 : @Dr. David Kirkby from Kirkby Microwave Ltd /g/nanovna-users/message/5324 20 October 2019 Hello, Thank you very much for your kind invitation. In fact, you violate open doors,

NanoVNA firmware uses poorly hardcoded memory address in the flash for store configuration. There is no check and it may overlap with the code. You're needs to check that.

#62 : On the Most Reasonable Questions with the Most Clear Answers Hello, Allow us, please, to think that it is now the right time to set the following, most reasonable, questions and give their

Yes, I agree... I assumed you are in a Register other than ZERO. But assumptions are bad! Good catch. Note, Register zero always comes up at first turn on. So I guess if you have a favorite sweep