I had the same reports.
But... the calibration runs well? (both 0.2.0. and 0.2.1) using the Calibration assistant.
73
Arie PA3A
Op 22-12-2019 om 19:00 schreef Dick W0QM:
toggle quoted message
Show quoted text
Hi Rune,
Thanks for a great interface program for the NanoVNA. I have run into a problem I do not understand in carrying out a calibration using nanovna-saver 0.2.1 (also 0.2.0). I have the frequency range set to 50 kHz - 50 MHz. If I use the Calibration assistant the calibration is accepted when I press Apply. However if I use the buttons, waiting enough time I believe between stages for the scan to complete, and press "Apply" I get the error box
" Error applying calibration
Two of short, open and load returned the same values at frequency 50016 Hz.
!
OK "
I have repeated this sequence several times and get the same error. I don't think I am making a mistake in connecting the calibration impedances. The calibration sequence works fine for me using the Calibration Assistant or using NanoVNA.exe. I must be doing something stupid that is not obvious to me.
73, Dick, W0QM
Arie Kleingeld PA3A