Hello Rune,
I am quite new to the group and am already scanning all the messages for information.
So please excuse, if I missed the information I am now askig for:
Which functions are taken over from your Software NanoVNA-Saver and which functions are still based on the Firmware.
e.g. I understand, you have your own calibration values for the correction of the traces, you do not use the values stored in the Firmware
my concrete questions:
- if I need small steps to measure a crystal filter (I read that the original old (September) Firmware has 100 Hz steps), can I do it with your software, or is the frequency generation taken from the firmware?
- to take a screen-shot, would I need an other Firmware and other PC-Programm, or is it also possible with your Software?
- Is there the need or proposal to use a specific Firmware to get all possibilities of your Software?
vy73 de Karsten, DD1KT
