On Thu, Sep 7, 2023 at 11:35 PM, Roger Need wrote:
You can easily build your own SMA female kit which works quite well. Use PCB
board SMA connectors with legs cutoff. Cut the centre pin flush for the open.
For the short use copper disc or foil and then flood with solder. The 50 ohm
load in the picture uses a 50 ohm SMD but use two 100 ohm resistors in
parallel for lower inductance and easier to find.
You can read about the performance of these on this site...
Interesting. But I have tried to solder between SMA connectors legs some time ago and it is hard. Soldering several resistors there is probably inpossible(for me). Putting a lot of solder everywhere seems to be much easier.
