Anne,
My knowledge and experience is limited, but SAVE 0 is loaded at power up
each time. This is a good place to save the calibration data for the setup
you use most often. Anything else you want to save, including a different
calibration, goes into one of the other SAVE locations and can be loaded
using the RECALL function. Hope this helps.
Perry
KG4KTB
toggle quoted message
Show quoted text
On Wed, Jun 8, 2022 at 4:05 PM Anne Ranch <anneranch2442@...> wrote:
Rich, what is really puzzling - assuming that the original intent of
father of "nanpXXXX" was to make money - why is internet full of
"wannabe" experts publishing and mostly copying stuff with little
regards to facts?
After I par6tially read one of the "beginners guide" I did same as you
did - made a copy of published document and started annotating it....
PS
As far as "SAVE" goes - I am sure I was "doing it wrong" , but after
pushing "DONE" I got an option to "SAVE 0 thru 3 ".
Now if I can repeat that process every time, I'll be a happy camper...
PPS
It still looks that after cycling power - SAVE 0 is "loaded" as
default....
