Herb,
Then it must have been a fortunate coincedence, it worked and therefore I thought it was OK, but now I remember that I had to start a terminal program for that, I did so some time ago. I will try again if the good operation consists, if not I will issue the command via my terminal program and see what happens.
Thanks
Jos
Op 21-2-2020 om 18:22 schreef hwalker:
toggle quoted message
Show quoted text
On Fri, Feb 21, 2020 at 09:09 AM, hwalker wrote:
On Fri, Feb 21, 2020 at 08:57 AM, Jos Stevens wrote:
I started NanoVNA-Saver from the command prompt with "Clearconfig" added and could perform a 1MHz-50MHz calibration and save it without NanaVNA-Saver being aborted.
==============================================================
Jos,
Just one thing. "clearconfig" does not work from the command prompt. It is a NanoVNA console command and has to be sent from a serial terminal. I assumed that is what you did but just wanted to verify. Otherwise, it may be just a fortunate coincidence that your issue disappeared and I would hate to pass on bad info in the future.
- Herb
