amhugo wrote:
Hi,
I have installed Kicad and just made up my first board, from schematic
to pcb. This software is really good and reminds me of the high-end
products (read expensive) we used to use at work. But I've come across
a problem.
I can print from the schematic just fine, in colour and B&W.
However when I try to print from the pcb editor, the print is
scrambled. I just get the top right corner printed but with large
vetical bars superimposed on top.
It looks like looking at the board behind prison bars!
I've tried different printers, inkjet and laser with the same result.
Any idea what I'm doing wrong?
Regards, Tony
Works fine for me under Linux. What scale did you use and did you do printer setup first?
Ian
--
Ian T-Bell
aka RuffRecords
aka RedTommo
www.geocities.com/ruffrecords
