Yes, just use four arcs to create the board edges. In the past I found that the arcs were approximated by a relatively small number straight lines, creating something that looked like a circle with notches. I don't know if that is still the case.
Note that circles don't make very efficient use of FR4, so if you can make the board polygonal (so it will tessellate) and still fit in the same space, then so much the better.
Regards,
Robert.
toggle quoted message
Show quoted text
On 24/01/2011 12:44, juliorz wrote:
Is it possible to make a circular printed circuit board using kicad?
---
avast! Antivirus: Inbound message clean.
Virus Database (VPS): 110123-1, 23/01/2011
Tested on: 24/01/2011 12:47:40
avast! - copyright (c) 1988-2011 AVAST Software.
--
() Plain text email - safe, readable, inclusive.
/\
