Hello,
??? Welcome to the group.
-
Can you specify where the pads
are too close together? If it's at the level of the
footprint of the transistors, you have to choose another one
or create one specific to your needs (it's very easy with a
little practice).
- Why do you use such thin cooper? And no ground plane ?
??? Regards,
??? Jean-Paul
****
Jean-Paul Gendner
03 88 27 03 44
Site :
toggle quoted message
Show quoted text
Hello, I'm new to using this software and pretty much everything
that has to do with PCB design and manufacturing products. I'm
currently trying to design and build a flashing LED circuit for an
engineering project. The issue I'm inquiring about has to do with
the closeness of the THT pads for my two transistors. When I
printed out the trace on a piece of paper from a PDF format, the
pads are extremely close together and my engineering teacher is
concerned that this will hinder the traces and will make it very
difficult to produce a working circuit. There is an attached
screen shot of the PDF.
