??? My picture is probabely not a good example. It is for a small HF
circuit and some times I prefer to get straith line between pads.
??? As there is a check box to be able to do so, I think it should
work, so probably I do some thing wrong.
??? Thank you,
??? Jean-Paul
****
Jean-Paul Gendner
03 88 27 03 44
Site :
Le 2021-12-15 ¨¤ 19:20, Alan Pearce via
groups.io a ¨¦crit?:
toggle quoted message
Show quoted text
On Wed, 15 Dec 2021 18:49:28 +0100
"jpgendner" <jean-paul.gendner@...> wrote:
??? I would like to connect the two "2" pads by an unbroken straight
line ? Regards,
Why? I would do it exactly as the picture shows. There would be an
extremely short straight bit within the as yet unconnected pad, and I
would prefer the track coming off the corner of the pad to prevent an
angle of less than 90 degrees between the track and pad to stop etch
solution inclusion in the angle. Any high reliability application will
require that this situation be avoided.
